Sloop IKARON is 30.48m and was built by Holland Jachtbouw. She was delivered in 2000 and refit in 2022.

Her hull, built in Aluminum, has a beam of 7.19m, a draft of 3.63m and was designed by Andre Hoek.

IKARON\'s MTU 6R 183 TE62 275 kW6 cylinder engines deliver 385 horsepower, enabling her to cruise easily at 9 knots and achieve a maximum speed of 11 knots.

Sloop IKARON can accommodate 8 guests in cabins, all looked after by a crew of 4.

IKARON is currently available for sale and is asking €2,900,000. She is available for viewings in Genoa, Italy.

 

 

• Full beam with two double beds either side

• Luxurious en-suite bathroom, with stall shower

• Two double twin cabins port and starboard forward

• Port forward cabin is equipped with an en-suite bathroom

 

 

• Two bunk cabins port and starboard

• Crew mess with U Shaped sofa, all electric controls

• Crew bathroom that doubles as an en-suite for the port forward guest cabin

 

• Two helm stations equipped with all sail controls

• Fantastic 360º views over and along the deckhouse

• Large table with U shaped sofa in blue leather port side

• Navigation and transmission equipment starboard side

• Steps into the upper deck salon and lower deck salon

 

2021

• Mast and rig pulled out of boat and all rigging removed for inspection

• All running rigging replaced

• Cabling, lights, and electronics checked, serviced or replaced

• Hydraulic furles serviced and rebuilt by Rondal

• Hydraulic halyard rams serviced

• Hydraulic aft stay tensioners serviced

• Hydraulic boom van serviced

• Mast & boom re-installed and tuned

• New Furuno radar and navigators installed

• New PC screens

• New cockpit resolution waterproof monitor

• New B&G processor and triton

• New Gyro-track compass installed

• All batteries serviced and or replaced

 

 

2022

• New electric motor

• Variable pitch gear box taken out, dismantled and serviced. All new

• Marine gearbox “Twin Disc” taken out and rebuild, new seals &

 bearings.

 

 

2023

• Under water Hull sand blasted, inspected

• Propeller, shaft, variable pitch system and gear box works:

• Variable pitch propeller “Teignbridge” dismantled and serviced

• Propeller shaft pulled out, taken to machine shop. Installed in lathe,

 checked for wear & torsion, cleaned. Was in perfect condition.

• Propeller shaft bearings serviced. oil and water seals, both engine

 room side and water side, all replaced.

• Propeller shaft oil bath oil replaced

• Propeller shaft aft “cutlass bearing” replaced

• Main engine rubber support blocks replaced (all 2 )

• Propeller shaft & main engine re-aligned. Boat sea trials showed

 perfect alignment.

• Rudder pulled out full service

• Rudder lower and upper bearings serviced

• Steering system & steering quadrant serviced

• New bearing Laghersmith

• Zink anodes new

• Brand new sails

• New tender Geniuss 320

• Offers access to the lazarette

• Hydraulic swim platform